MasonrySaver #25 Floor Finish 1 Gallon

MasonrySaver #25 Floor Finish 1 Gallon

$44.15
+
-

MasonrySaver® #25 Floor Finish is formulated to be applied directly over MasonrySaver® Decorative Concrete Sealer, providing a rich, gloss finish that resists dirt and floor scuffing, and prolongs the floor life of Decorative Concrete Sealer.

MasonrySaver® #25 Floor Finish has been formulated for use on interior horizontal concrete surfaces. Surface and air temperature should be between 50°F and 90°F. Do not apply to surfaces that are damp or wet.

Surface Preparation (New Floors):

  • New floors should first be properly cleaned, stained and sealed per manufacturer’s directions.
  • When sealing, use MasonrySaver® Decorative Concrete Sealer, or a comparable product.
  • Allow sufficient time for sealer to properly cure prior to applying #25 Floor Finish.


Surface Preparation (Previously Sealed Floors):

  • Strip floors thoroughly to remove old wax and floor finish. Rinse floor thoroughly with clear water and allow to dry.
  • If sealer coat has broken down to an uneven finish, reseal the floor using MasonrySaver® Decorative Concrete Sealer prior to applying #25 Floor Finish.
  • Daily sweeping and dust mopping is critical for any floor care program. Damp mop with a neutral cleaner to remove dirt and other surface contaminants prior to buffing. MasonrySaver® #25 Floor Finish can be high-speed buffed to achieve a rich, high gloss finish.
  • A maintenance coat of #25 Floor Finish should be applied when the floor begins to exhibit an uneven sheen. For reapplications, three coats of finish should be applied to traffic areas and a single coat of finish should be applied in non-traffic areas.

Comments (0)

Subscribe to this comment's feed

Show/hide comments

Write comment

smaller | bigger

busy

DEFY Water Repellent for Vertical Brick is a modified siloxane based product designed to penetrate deeply in to most masonry and concrete pores. This masonry waterproofing product allows deep penetration of its active ingredient of up to 1/4 inch or more.

The special siloxanes in DEFY Water Repellent for Brick react to form strong chemical bonds beneath a treated surface. These bonds allow the product to become a physical part of the structure and provide long-lasting water repellent protection without altering the appearance of the brick. DEFY Water Repellent for Brick treatment is 100% vapor permeable, which allows the water moisture to escape. This reduces costly chimney repair such as spalling, scaling, deterioration, and freeze-thaw damage that results from trapped moisture when clear coatings and water sealers are used for waterproofing brick.

MasonrySaver #25 Floor Finish 1 Gallon | Decorative/Stamped Concrete Sealers | Concrete Sealers | BrickPaverSealer.com
Your Cart is currently empty.

Defy Brick Water Repel Info

Gallon Sizes:
1's & 5's
Coverage Per Gallon:
Brick: 100-150
Block: 50-75
Concrete: 75-150
Stucco: 75-150
Limestone: 75-150
Temperature:
40 F Minimum
Application Tools:
Sprayer
Dry Time:
1-2 Hours
Cleanup:
Water & Soap
More Info:
Product Data